Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to protect cars from hacking or key cloning, is a small device that can be installed without damaging your vehicle. It stops your car from starting until you press the correct sequence of buttons inside your vehicle, similar to a password on the phone.

Stop/Start

Ghost Immobilisers prevent vehicles from being stolen by blocking the engine from starting until it has the correct PIN code. This is accomplished without altering the vehicle, and is undetectable by thieves. The unit communicates with the ECU via the CAN data bus to immobilise the vehicle. This system is very like the one automobile manufacturers have used in their vehicles for a long time however, the criminal cannot add a new key or use key relay technology to bypass it as they could with factory-installed systems.

Ghost is compatible with any vehicle with an engine, which includes cars, vans, motorhomes and caravans, as well as bikes. The same system can also be used on electric vehicles. It is a great alternative to wheel clamps and steering wheel locks.

When the Ghost is armed it will block all the buttons in your car and stop the ignition from being started until a PIN code has been entered prior to. This can be done via the Android or Apple mobile app or by entering the code via your key fob. If a wrong code is entered the app will show an indicator light and the Ghost will not allow the vehicle to start again. This is a great deterrent and when the vehicle isn't initiated, the criminal will move on to another target.

The Ghost is tiny, weatherproof device that can be hidden in the most difficult to reach parts of your car. Installation takes between 20 and 30 minutes for each vehicle. It is also easy to remove should you choose to switch your vehicle or hand it in for valet parking or service. It is a TASSA (Tracking and Aftermarket Security Systems Association) an insurance-approved system, and is recognized by certain insurance companies. It also has a secure emergency Pin Code Override, and the Service/Valet feature that can be activated by pressing a button on the app or by using your key fob.

Disarm

Ghost immobilisers like mechanical anti-theft devices that can be removed, are concealed in the car. Even if they were discovered and stolen, thieves would not be able to start the vehicle. They are virtually impossible to bypass or hack. This is because a ghost immobiliser prevents key hacking, signal jamming and device spoofing - methods that are used frequently by thieves to gain entry into vehicles with standard immobilisers.

An immobiliser operates by sending an instruction to the ECU (electronic control unit). If the wrong code is received and the vehicle is not launched as the engine will not fire up. It is possible to disable a ghost immobiliser using an application program, but it is very difficult and time consuming to accomplish this. Only an authorised installer can install and use the software.

The Ghost immobiliser is a tiny device that is part of the wiring loom of your vehicle and is inaccessible to the naked eye after it has been installed. It does not appear on diagnostic systems. There are no indicators with LEDs, and it isn't able to communicate with the engine via the OBD port. It communicates in a silent manner through the CAN data circuit.

The system will not allow the vehicle to start until it is given an input PIN code defined by the user. This code can be entered using buttons on the steering wheel and door panels as well as the central console. This is a how much is a ghost immobiliser (click through the following website page) safer method of protecting your vehicle as it does not require keys or a remote control.

In addition, Ghost has a service mode which can be activated by using the application on your mobile phone. This lets you give your keys to someone else for valet parking or service without the need to enter the disarm sequence.

You should not remove the system on your Ghost by yourself, regardless of whether it is in service mode. This could damage the engine. It is recommended to contact a TASSA certified installer who can remove the system in a safe and secure manner. Our most recent GHOST II immobilisers also come with a special QR fingerprint sticker that is hidden in various areas of your vehicle. they are linked to our global security register - in the event the system is removed and sold on the black market this will link it back to its original owner.

Anti-Hijack

The anti-hijack feature is an essential feature of the Ghost immobiliser ghost 2. This is a sophisticated key that guards your car from theft. If the ignition switch is switched to on, and the vehicle is stationary for a period of 30 seconds then the Ghost system will stop the engine and switch the hazard lights on. This allows the driver and passengers enough time to press the secure button before the system is reactivated.

In contrast to other systems that simply stall the engine whenever the ignition what is ghost immobiliser switched on and on, the Ghost system has a unique controller and timer unit that will close the valve for cutting off fuel 14 in the event that it is activated within an agreed-upon time even in the event that the ignition is switched on! This delay time period needs to be long enough to allow the owner of the vehicle who was hijacked of the vehicle to move away from the location of the incident and to maintain a sufficient distance from the vehicle in which it is stuck before the system is able to reactivate.

In addition to the standard CANbus immobiliser blocking capabilities of the Ghost system, it also comes with an extra level of security that prevents common hacking techniques that are used to hack into modern vehicles like relay attacks key range extending, key range hacking and ECU swapping. The Ghost system communicates in a quiet manner and how much is a ghost immobiliser does not emit signals that could be detected by thieves using codes-grabbing or RF scanning technology.

The Ghost system also has the option of a Service/Valet mode that allows your vehicle to be temporarily re-started and driven without the requirement of a PIN code. This is ideal for parking your car and need to leave it for a short period of time, for example, to store groceries in the boot or open a garage door, etc. The system will end the service mode based upon speed and time or by the simple input of a PIN code process. This gives you total assurance that only you can drive your vehicle!

Keyless Entry

Many consumers are now looking for extra security measures due to the increasing trend of contactless car theft. This is especially relevant for those who have invested time and money into customising their car or own expensive automobiles. Add-on immobilisers can be an effective method to stop this type of theft because they will stop your car from starting until the proper pin code is entered, along with your key fob.

Immobilisers are designed to intercept various vehicle circuits such as those that control the starter motor and the fuel pump. They also can shut down the car alarm to draw attention to and frighten away any potential thieves.

These devices communicate with the engine control unit (ECU) through the CAN data circuit. They also they stop a burglar trying to get around it by installing a brand new ECU or How much is a ghost immobiliser using a key programmer. The immobilisers are fitted discretely and do not leave any marks in your vehicle. They are also undetectable with the latest tools of thieves.

The Ghost immobiliser is different from other systems that require drivers to carry a tag or an app. Instead, you are able to select your own pin sequence by pressing an image on your steering wheel, door panel, or centre console. The pin can be changed as frequently as you'd like, meaning it is as secure as a credit card, and can be even more difficult to hack due to the fact that it requires up to 20 presses.

Ghost also has the option of a valet/service mode that allows you to disable the system when your vehicle is going to be handed over to valet parking or for service, enabling it to operate within predetermined parameters such as 30mph speed limits, so you don't have to worry about your car being driven recklessly. The system can be reactivated using the original key or entry code.

Installed by our certified installers, it is the most secure and efficient aftermarket CAN-immobiliser that is available. It is also accepted by Thatcham for insurance purposes. The Ghost 2 immobiliser is also supplied with six QR fingerprint labels, an ISR contact card that contains your unique QR code, as well as a secure emergency code which you keep in the wallet/purse of your vehicle.